People Also Liked

UPDATE Quickfix Smith&Wesson SD9VE Malfunction and failure.

Posted by Roosted films
Finally getting to the range to do an update on my SD9VE magazine quick fix. Gun Streamer https://gunstreamer.com/@Roostedfilms Gun Channels https://gunchann...
Posted September 21, 2018
click to rate

Embed  |  173 views
7 comments
  • Rupan, Gwebs, and travisp11 like this
  • DrGno
    DrGno That should be easy enough to check, might need an extra pair of hands though, insert en empty mag & pull down on the base while someone slingshots the mag. That's another things too, althought I've never seen it successfully address the issue in person...  more
    September 21, 2018 - 1 likes this
  • DrGno
    DrGno Oh heres a tip, on the slide lock lever, stick a piece of tape on the bottom of the tab, inset empty mag & rack the slide. If it locks, ok, if not, put another piece of tape, repeat. when it starts engaging positively then the thickness of the tape is...  more
    September 21, 2018 - 1 likes this
  • Roosted films
    Roosted films Both GREAT ideas and I will be trying them both this afternoon. THANKS again Doc
    September 21, 2018
  • travisp11
    travisp11 On my SD9VE if I put any pressure on the mag plate, it will cause the slide to not lock open on the last round. I have not stretched out my mag springs as I think it is just a loose tolerances issue.
    September 21, 2018